Specs
Install
When you replace incandescant turn signal bulbs with LEDs in most vehicles, the vehicle will start hyperblinking because the LED uses much less power, and the vehicle thinks the bulb is out. You can use these resistors to fix the problem of hyperblinking when you convert to LED bulbs.
Diode Dynamics resistors have extra-long 8" leads for easier installation, and have a rating of 50w, 6ohm. This is usually enough to compensate for one bulb. If you are installing four LED turn signals (front and rear) we recommend four total resistors.
Included with your order:
- 4 resistors
- 8 quick-splice "scotch-lock" connectors
Installation: Connect one side of the resistor to the positive turn signal wire, and the other side to negative (ground) with included connectors.
Specifications
Installation
NOTE: Resistors will be hot to the touch when the turn signal is activated for a prolonged period of time. This is normal operation. We recommend mounting the resistors away from any plastic, wires, or fabric.
Installation Time: 20-30 minutes
Tools Needed: Basic Toolset
Modification: Basic Wiring Only
Installation Guide: Click to download
Warranty
3 Year Replacement Limited Warranty
All Diode Dynamics products come with a 3 Year Worry-Free Warranty.
If you experience any defect with a product, we will do some quick troubleshooting, and if necessary, provide a replacement. There is no need to wait for a return and repair process. Click here to learn more.
