TALK TO A LIGHTING EXPERT314-205-3033M-F 9-5 CST

LED Resistor Kit

You could receive 20 Diode Points for writing a review for this product.

Availability: In stock

Ships today if ordered in the next 5 hours and 52 minutes!

$10.00
Fix hyperblinking in any vehicle!
 
Add to Wishlist

LED Resistor Kit

More Views

Customer Images
Earn $1.00 store credit! Upload a picture of this product installed for 20 Diode Points. (2MB limit)

When you replace incandescant turn signal bulbs with LEDs in most vehicles, the vehicle will start hyperblinking because the LED uses much less power, and the vehicle thinks the bulb is out. You can use these resistors to fix the problem of hyperblinking when you convert to LED bulbs.

Diode Dynamics resistors have extra-long 8" leads for easier installation, and have a rating of 50w, 6ohm. This is usually enough to compensate for one bulb. If you are installing four LED turn signals (front and rear) we recommend four total resistors.

Included with your order:

  • 2 resistors
  • 4 quick-splice "scotch-lock" connectors

 


Installation: Connect one side of the resistor to the positive turn signal wire, and the other side to negative (ground) with included connectors.

Year No
Make No
Model No
Application No
  1. Fixes hyperblink Review by Jimmy
    Price
    Value
    Quality

    Easy to install. Simple design, just wish the leads were longer and come with screws for mounting. (Posted on 10/19/16)

  2. Must have with Install suggestions Review by JoeBob
    Quality
    Price
    Value

    Great Product

    Use stainless screws #6x1/2"
    Prime holes drilled into body mount points
    Add extra heat shrink over the original solder joints, flexing these will break the supplied heat shrink leaving the solder joint exposed to moisture
    Be mindful of rub points as you route the wiring and add extra heat shrink to protect.
    Use wire ties to prevent floppy and loose wire routes
    Do not use the quick connector clips. Solder joints are always better in the long run, heat shrink and wrap well with quality electrical tape. (Posted on 9/9/16)

  3. Good product Review by JC15GT
    Price
    Value
    Quality

    I purchased these for my 2015 Magnetic Metallic GT. I did not like the hyper blinking sound on the inside of the car, so I installed these. They were a pain to install just because of the lack of space when the wheel is still on the car. I would recommend taking the wheel off. (Posted on 5/9/16)

  4. Great product Review by Perfect
    Price
    Value
    Quality

    Exactly what I needed to fix hyper flash on my turn signals. Like all their products easy to install and works as advertised. (Posted on 4/29/16)

  5. Good product prompt service Review by Gorillaz03
    Price
    Value
    Quality

    The resistors I received worked great and I was able to install in about 30 min. I ended up using different connectors then the supplied ones but that was just a personal preference thing. Product works great and I received them within a few days of ordering. (Posted on 4/13/16)

  6. Hyperblink No More! Review by Josh U
    Price
    Value
    Quality

    Installation was simple and quick. The purchased resistors do exactly what they are supposed to do. The hyperblink issue with my new LED lights is completely gone. (Posted on 2/22/16)

  7. Could be better Review by Sid
    Price
    Value
    Quality

    Unlike their amazing LEDs, I wasn't impressed with Diode Dynamic's resistor kit. Besides the black color I don't see the benefit of buying these over the plethora of cheaper alternatives available elsewhere. The quality of the plastic splices wasn't that great and one of my wires had a sharp piece of solder sticking out where the insulated wire is soldered to the resistor wire. But overall the price isn't too bad and they worked fine so I'm still satisfied, I was just expecting more. (Posted on 2/2/16)

  8. Easy to install Review by Buzz
    Price
    Value
    Quality

    I installed these on my stop/taillight to make my cruise control work again and to eliminate the traction control light from coming on. They go on the red wire and the black wire, the green wire is the signal wire for the brake lights. (Posted on 1/10/16)

  9. So simple and perfect! Review by Eric91Z
    Price
    Value
    Quality

    I love plug and play. With these and the video, there is no issues with hyperblinking once installed. Used these on the front turn/indicator and rear tail/turn combos (1 at each corner) and everything is working perfectly with the newly installed LED bulbs at each location. So far no issues at all. (Posted on 1/8/16)

  10. LED Resistor kit Review by Dave
    Price
    Value
    Quality

    Cured hyperflash of turn signals. Simple install. Shipped and received promptly. Genuinely pleased. Thank you. (Posted on 11/3/15)

  11. Great Resistors! Review by Doug
    Value
    Quality
    Price

    These resistors are small and very easy to install! Got rid of the 'hyper-flashing'. (Posted on 8/11/15)

  12. Excellent Value Review by 2015 GT PP
    Value
    Quality
    Price

    Ordered this LED Resistor Kit for my 2015 Ford Mustang GT Performance Pack. I recently purchased the Diodedynamics Switchback LED Kit and this LED Resistor Kit did fix the hyper-flashing turn signals that my car had as a result of the LED lights. However, I could not give a review of 5 stars because the provided splice connectors are not of the same quality of the resistors as a result of severed wiring utilizing this connector. I was able to resolve the issue by solder-splicing the connection. My experience could be very frustrating to individuals that have very little electronic repair experience if they have the same results. Highly recommend a quality connector, especially with the limited amount of room available to perform this installation on this type of vehicle. (Posted on 8/3/15)

  13. For my front & rear turn signal Review by Ron
    Price
    Value
    Quality

    Easy install to avoid hyperflash on my 2014 Kia Sorento. Great product, not disappointed & worth getting. (Posted on 6/16/15)

  14. Great quality and awesome products Review by DDD
    Price
    Value
    Quality

    I ordered the resistor kit for addressing my bmw e38s hyper blinking. The kit was sent quickly all the way to India and was in good condition. Easy installation. And voila the issue was resolved. DD also give you all the information you may need for installation and safety. Grt service. Will buy more. (Posted on 5/18/15)

  15. LED load Resistors Review by Dodgehemi61
    Price
    Value
    Quality

    There resistors are the perfect match for LED installation. Easy to install, and work great with my switchback LED's.
    Fast shipping and great service. (Posted on 5/17/15)

  16. Work great!! Review by Mike
    Price
    Value
    Quality

    These resistors do exactly what they are supposed to do. No more hyperblinking. The signal lights blink like normal now. They do get very hot so just make sure to keep them away from other wiring and anything plastic, just mount them to a metal surface and you will have no problem. Great product. (Posted on 4/25/15)

  17. great! Review by 04 Grand Prix
    Price
    Value
    Quality

    Perfect fix for my LEDs. No more hyperlink, easy to install. (Posted on 4/13/15)

  18. Worked as advertised Review by R.A.
    Price
    Value
    Quality

    I installed these recently using a mounting plate from a different online vendor. These worked as advertised. In combination with the aluminum mounting plates, they do not get that hot at all. (Posted on 4/7/15)

  19. works like a charm Review by AD
    Price
    Value
    Quality

    Installed these on my 2004 grand Prix after I replaced my parking lamps with LEDs. Got rid of the hyperblink and warning lights. (Posted on 3/20/15)

  20. Awesome Review by SR
    Quality
    Price
    Value

    Was having a problem with hyperblinking on our 2012 Taurus!
    These baby's fixed it right up,

    Thank you!
    (Posted on 1/24/15)

Worry-free warranty

  • - Full 3-year warranty on all products
  • - No waiting: we usually send new items out with a return label (US customers only)

 

You will get quick help from our trained staff for any issues.

All Off-Road Lighting also carry a limited lifetime warranty.

For further details, please see our full article.

Domestic (US) Customers

  • - Just $5 per order with our Diode Delivers program
  • - Same-day shipping for all orders placed by 12:00 PM CST (or until 4 PM with rush processing)
  • - USPS, for delivery in 2-4 days (on average)
  • - Express services are available, see exact pricing at checkout
  • - Fully Insured

 

International Customers

  • - We ship to all countries via standard mail
  • - Usually around $10 for LEDs, or $25 for HIDs.
  • - Choose your service on checkout to see exact prices:
  • - USPS 1st Class: 2-5 weeks
  • - USPS Priority: 1-2 weeks
  • - Express EMS: 1 week
  • - Please email us if you are unsure about shipping to your country.


You will receive updates from our site when your order is shipped, along with a unique shipment number to ensure that your order is correctly accounted for. This allows you to easily reply to us if you have any concerns.

Whether your order is big or small, it is tested through many run cycles, and each bulb is tested before shipment. Every single bulb. Every time. And if anything does go wrong, you can rely on our industry-leading warranty for worry-free replacement.

If you're not happy with your items, we want to make it right. So we have some pretty awesome return policies:

Returns

30 day return policy. All customers have 30 days from the date of original order shipment to return items.

Full refund, no fees. At Diode Dynamics, we offer free returns. That means no restocking fees, no administrative fees, and no hassle!

 Free return label. If your original order was over $50, you get a free return label for your items (US customers only). If your order was less than $50 or international, you can send the items back through your preferred method.

Exchanges

Within 30 days: If your original order was over $50, you can get new items shipped to you with a return label (US customers only). If your order was less than $50 or international, we can send you the new items first, but you are responsible for returning the old items.

Within 90 days: Any item can be returned for exchange or store credit within 90 days. The buyer is responsible for the cost of the return shipping, and must first return the old items. We'll still cover the postage for the new items.

 

Please note: due to the nature of custom acrylic pieces, we cannot offer any refund or exchange for returned custom acrylic items.

 

To make a return or exchange, please request an RMA, or give us a call. When we get it back, you will be notified and credited appropriately.

Again, all returns must be approved, with an RMA. This is so that we can process your return as quickly as possible when we get it. If you would like to return an item, please Request an RMA. Please include as much information as possible about the reason for return.

Alternatively, you can also send us a message, or give us a call!